12V 3A Laser etched ON-OFF OEM Replacement Push Switch with dual blue LED lights for
TOYOTA PRADO 150s 08/2017 - Onwards
TOYOTA HiAce 02/2019 - Onwards
TOYOTA RAV4& RAV4 Hybrid 01/2019 - Onwards
TOYOTA Camry 70 Series 09/2017- Onwards
TOYOTA Corolla 06/2018 - Onwards
NEW Square Push Latching type Switch Designed FOR:
Please check the hole size before purchase
This 12 volt push switch from AOB is a single throw ON - OFF switch designed to operate your 12 volt accessories. It has a face surface size of 22 mm x 22 mm and uses the original mounting hole of the vehicle.
This Switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.
AOBSWT100 series
Rear picture showing terminals and wiring harness supplied with switch
Wiring diagram will be supplied with switch purchase.
AOBSWT100 series Illumination
When switch is turned on the top light illuminates.
The bottom Etching (words) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.
(this is a sample image with the LED LIGHT BAR logo)
Switch Logo | HEATED MIRRORS B78 |
---|---|
Switch_Type | ON-OFF |
Switch_Layout | VERTICAL |
Toyota_Model | Camry 70s 2017 ~, Corolla 2018 - Current, HiAce 2019 - Current, Prado 150s 2017 - Current, RAV4 2019 - Current |
Material | Plastic |
Color | BLUE BLUE |
Lights | Dual backlit LED lights. Upper light is ON when the switch is pressed UP. Lower light can be wired to separate dash light circuit. |