NEW VW AMAROK OEM Replacement Switch with chrome strip FOR CENTER
Suits : VW Amarok 2016 onwards top dash only (updated model)
Match factory colour RED dash lights
Turns AMBER when activated
Same as factory switches
Please check the following before making your purchase
Switch location do you require: LEFT, CENTER or RIGHT side switches
With Chrome strip or without
ONLY FITS Amarok 2016 onwards update
This high quality 12V 3A push switch from AOB is a single throw ON - OFF switch designed to operate your 12 volt accessories. It has a face surface size of 30 mm x 24 mm and length of 52 mm and uses the original mounting hole of the vehicle.
This switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp's
Therefore in ALL cases the accessory MUST be wired through a fused relay.
Rear picture showing terminals and wiring harness supplied with switch. Wiring diagram will be supplied with switch purchase.
Amarok Switches Illumination
With dash lights switched on light illuminates RED matching the factory red illumination
When switch is activated the light changes from RED to AMBER
The RED light has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, it's your choice.