Nissan OEM Replacement Push Switch
|Pathfinder||R52||2012 - Current|
|Navara||NP300||2015 - Current|
|X-Trail||T32||2014 - Current|
This high quality 12 volt push switch from AOB is a single throw ON - OFF switch designed to operate your 12 volt accessories. it has a face surface size of 30 mm x 23 mm, length of 53mm and uses the original mounting hole of the vehicle.
This switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's..
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.
Rear picture showing terminals and wiring harness supplied with switch.
Wiring diagram will be supplied with switch purchase.
Nissan Switches Illumination
When switch is turned on the bottom light (picture 3) illuminates.
The top Etching (image) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.
(this is a sample image with the SPOT LIGHTS logo)
|Switch Logo||SPOT LIGHTS 23|
|Electric_ Rating||12V 20A|
|Lights||Dual backlit LED lights. Upper light is ON when the switch is pressed UP. Lower light can be wired to separate dash light circuit.|
|Nissan_Model||Navara NP300 2015 - Currrent, Pathfinder R52 2012 - Currrent, X-Trail T32 2014 - Currrent|