Marine Rocker Switch 6M42R Laser ON-OFF AUTO PILOT RED
As low as £7.90
12V 20A / 24V 10A Laser etched Rocker Switch 6M42R AUTO PILOT dual LED red ON-OFF
Out of stock
SKU
SW6M42R
12V 20A / 24V 10A ON - OFF Marine Rocker Switch
This high quality 12V/24V Rocker switch from AOB is a single throw ON - OFF switch designed to operate your accessories.It has a face surface size of 49mm x 26mm and uses a standard din size mounting hole of 37.5mm x 21.2mm. This is the standard size of most switch holes in modern boats, however it is best to check your particular hole size if unsure.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is rated to 20amp at 12V and 10amp at 24V however in ALL case we recommend that you wire the accessory through a fused relay.
AOBSW6M00 series
Rear picture showing terminals. Wiring diagram will be supplied with switch purchase. Independent wiring circuit to connect dash lights
AOBSW6M00 series Illumination
When switch is turned on the top light (picture 1) illuminates.
The bottom light (bar) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.
(this is a sample image with the Zombie light logo)
| Switch_Cover_Type | Laser etched |
|---|---|
| Switch_Type | ON-OFF |
| Switch Logo | AUTO PILOT M42 |
| Color | RED RED |
| Material | Plastic |
| Switch_Layout | VERTICAL |
| Electric_ Rating | 12V 20A / 24V 10A |
| Lights | Dual backlit LED lights. Upper light is ON when the switch is pressed UP. Lower light can be wired to separate dash light circuit. |
| MountingHole_Size | 37.5mm x 21.2mm |
| Waterproof_Rating | IP66 |
| Suitable To | Boats |
Write Your Own Review